Current as of October 03, 2022 | Updated by FindLaw Staff
Welcome to FindLaw's Cases & Codes, a free source of state and federal court opinions, state laws, and the United States Code. For more information about the legal concepts addressed by these cases and statutes, visit FindLaw's Learn About the Law.
(a) There must be an alternate means to control the propulsion and steering system which must:
(1) Be independent of the primary control required by § 143.225;
(2) Be located at or near the propulsion and steering equipment; and
(3) Be readily accessible and suitable for prolonged operation.
(b) There must be a means to communicate between each operating station and the alternate propulsion and steering controls.
(c) There must be a means to stop each propulsion engine and steering motor from each operating station.
(d) The means to monitor the amount of thrust, rudder angle, and if applicable, direction (ahead or astern) of thrust must be independent of the controls required by § 143.225.
(e) The propulsion control system required by § 143.225 must be designed so that, in the event of a single failure of any component of the system, propeller speed and direction of thrust are maintained or reduced to zero.
(f) On a towing vessel with an integrated steering and propulsion system, such as a Z–drive, the control system required by § 143.225 must be designed so that, in the event of a single failure of any component of the system, propeller speed and direction of thrust are maintained or the propeller speed is reduced to zero.
(g) An audible and visual alarm must actuate at each operating station when:
(1) The propulsion control system fails;
(2) A non-follow up steering control system fails, if installed; and
(3) The ordered rudder angle does not match the actual rudder position on a follow-up steering control system, if installed. This alarm must have an appropriate delay and error tolerance to eliminate nuisance alarms.
(h) Alarms must be separate and independent of the control system required by § 143.225.
(i) A means of communication must be provided between each operating station and any crewmember(s) required to respond to alarms.
(j) The two sources of electricity required by § 143.555(a)(3) and (b)(8) must be capable of powering electrical loads needed to maintain propulsion, steering, and related controls for not less than 3 hours.
(k) The second source of supply required by § 143.555(a)(3) must automatically start to help restore or maintain power to propulsion, steering, and related controls when the main power source fails.
(l) Propulsion, steering, or related controls that are directly reliant on stored energy, such as compressed air, battery power, or hydraulic pressure, must have two independent stored energy systems, such as compressed air cylinders, battery banks, or hydraulic cylinders, that are capable of maintaining the vessel's propulsion, steering, and related controls.
(m) After a power failure, electrical motors used to maintain propulsion and steering must automatically restart when power is restored, unless remote control starting is provided at the operating station.
Cite this article: FindLaw.com - Code of Federal Regulations Title 46. Shipping § 46.143.585 General requirements for propulsion, steering, and related controls on vessels that move tank barges carrying oil or hazardous material in bulk - last updated October 03, 2022 | https://codes.findlaw.com/cfr/title-46-shipping/cfr-sect-46-143-585/
FindLaw Codes may not reflect the most recent version of the law in your jurisdiction. Please verify the status of the code you are researching with the state legislature or via Westlaw before relying on it for your legal needs.