Learn About The Law
Get help with your legal needs
FindLaw’s Learn About the Law features thousands of informational articles to help you understand your options. And if you’re ready to hire an attorney, find one in your area who can help.
Code of Federal Regulations Title 40. Protection of Environment § 40.63.8800 What performance tests and other procedures must I use to demonstrate compliance with the emission limit for flame lamination?
Current as of January 02, 2025 | Updated by Findlaw Staff
(a) You must conduct each performance test in Table 3 to this subpart that applies to you.
(b) Each performance test must be conducted according to the requirements in § 63.7(e)(1) and under the specific conditions in Table 3 to this subpart.
(c) You may not conduct performance tests during periods of startup, shutdown, or malfunction, as specified in § 63.7(e)(1).
(d) You must conduct at least three separate test runs for each performance test required in this section, as specified in § 63.7(e)(3). Each test run must last at least 1 hour.
(e) You must determine the percent reduction of HAP emissions during the performance test according to paragraphs (e)(1) through (3) of this section.
(1) If you use chlorinated fire retardant foams, determine the percent reduction of HCl to represent HAP emissions from the source. If you do not use chlorinated fire retardant foams, determine the percent reduction of HCN to represent HAP emissions from the source.
(2) Calculate the concentration of HAP at the control device inlet and at the control device outlet using the procedures in the specified test method.
(3) Compare the calculated HAP concentration at the control device inlet to the calculated HAP concentration at the control device outlet to determine the percent reduction over the period of the performance test, using Equation 1 of this section:
Where:
R=Efficiency of control device, percent.
Einlet,i=HAP concentration of control device inlet stream for test run i, mg/dscm.
Eoutlet,i=HAP concentration of control device outlet stream for test run i, mg/dscm.
n=Number of runs conducted for the performance test.
(f) You must also meet the requirements in paragraphs (f)(1) and (2) of this section.
(1) Conduct the performance tests using foams that are representative of foams typically used at your flame lamination affected source. If you use foams containing chlorinated fire retardants, you must conduct the performance tests using these foams.
(2) Establish all applicable operating limits that correspond to the control system efficiency as described in Table 3 to this subpart.
Cite this article: FindLaw.com - Code of Federal Regulations Title 40. Protection of Environment § 40.63.8800 What performance tests and other procedures must I use to demonstrate compliance with the emission limit for flame lamination? - last updated January 02, 2025 | https://codes.findlaw.com/cfr/title-40-protection-of-environment/cfr-sect-40-63-8800/
FindLaw Codes may not reflect the most recent version of the law in your jurisdiction. Please verify the status of the code you are researching with the state legislature before relying on it for your legal needs.
Was this helpful?
Latest Blog Posts
-
Executive Order Strips Protections From More Career Federal Workers
-
Alleging a Culture of Racism, Bigotry, and Misogyny, Karen Read Sues Police for Negligence and Conspiracy
-
How Host Cities Are Changing Alcohol, Surveillance, and ID Laws for the World Cup 2026
-
Massachusetts Attorney General Sues UHC for $100 Million, Alleges Medicaid Fraud
-
Explore all
